Waste Film Plastic Pelletizing Line Application:
PP PE PA PS LDPE Film Plastic Pelletizing Line is a single-stage plastic regenerative pelletizer, which is suitable for many kinds of plastic waste materials recycling and making pellet, such as PP, HDPE, LDPE, LLDPE Film and clean woven/nonwoven bag materials, etc. The film can be pressed in the compressor and then be pelletized. Single stage plastic pelletizing line is mainly suitable for materials such as film printed film industrial membranes and other materials and impurity content, if it is high moisture and impurity content, it is recommended to choose double stage plastic granulator.

PP PE PA PS LDPE Film Recycling Plastic Pelletizing Line General Specifications:
WANROOETECH recycling technology for processing films, fibers, and washed post-consumer waste from materials such as PE, PP, PA und PS. This line is suited to all polyolefin and technical plastics and is ideal for processing hygroscopic, moist, and/or pre-ground materials. The PNHS basic plastic pelletizing line is equipped with an agglomerator drum tangentially mounted at the extruder. In the agglomerator, the material is collected, cut, dried, and thermally compacted. A knife disk at the bottom of the drum, rotating at high speed, cuts the material. The heat from the cutting process and friction dries the material and raise the temperature to just under melting point. The rate of material feeding is controlled automatically by the load on the agglomerator motor, and the compacted material is fed continuously to the extruder. The machine is designed so that overloading and underloading are avoided. The PNHS basic series comprises five machine sizes which together cover an output range of 80 – 600 kg/h. Each machine can be equipped with degassing, high vacuum, full auto non-stop screen changer (filter) and any one of three pelletizing systems.

Hot Die Water Ring Plastic Pelletizing Line Description:
WANROOETECH water ring plastic pelletizing line connects directly to the end of the extruder, WANROOETECH screen Changer, or Melt Pump via a short-coupled adapter allowing the polymer to flow horizontally from the extruder to the in-line die plate. The theologically optimized design minimizes polymer inventory between the extruder and die plate and evenly distributes polymer flow to each die plate hole. The result is a consistently uniform pellet.
Reclaim, masterbatch, and compounders will benefit from improved pellet quality during both short and extended production runs.
The in-line design reduces inlet pressures which can allow for increased production rates. Polymer purges quickly through the in-line die plate for quick color changes, which maximize production time. The retractable cutter head allows quick access to change blades and remove die plates for cleaning or screw removal.
An open trough cooling system allows easy operator response to process changes.
A new cylindrical pellet dryer provides improved 360° access to the dryer rotor for cleaning and pellet removal. Pellet flow through the dryer is streamlined to eliminate pellet stagnation and promote efficient pellet drying. An integral dryer blower exchanges dryer air 50 times per minute to provide improved pellet dryness.

PP PE PA PS LDPE Film Recycling Plastic Pelletizing Line Benefits:
Uniform polymer flow to die plate
Lower inlet pressure = increased rates
Rapid blade and die plate removal
Fast color changes
Easy clean-out
Simple start-up and operation
Improved pellet dryness
Easy dryer access and cleanability
Insensitive to process variations

PP PE PA PS LDPE Film Recycling Plastic Pelletizing Line Features:
In-line cutter geometry
Retractable cutter head design
Open water trough
New cylindrical pellet dryer
Integral dryer blower
Fully interlocked control system
Independent pellet cut

Video